Beaglebone black xterm uxterm q terminal11/19/2022 ![]() This prevents placing U-Boot SPL/MLO there. If you still want to use the MMC as a disk, then it must have a Master Boot Record (MBR) containing one or more partition table entries at 0x00000. #Beaglebone black xterm uxterm q terminal code#In RAW mode, the ROM code will search sector #0 (offset 0x00000), sector #256 (0x20000), sector #512 (0x40000) and sector #768 (0圆0000) for a TOC structure/Configuration Header. In more recent times, the RAW mode has been adopted. The full/second stage U-Boot would contain hard-coded environment variables to load uEnv.txt as the environment variables couldn't be saved using saveenv. The card would contain two partitions, a FAT32 partition and Linux ext3/4. Alternatively, if using eMMC, the bootloader can be loaded using RAW mode.Įarly BeagleBone Black images included MLO (and u-boot.img) on a FAT file-system in the root directory of the active primary partition. #Beaglebone black xterm uxterm q terminal 32 bit#The ROM code will try to load and execute the first stage bootloader called "MLO" (U-Boot SPL) from a Fat 12/16 or 32 bit MBR based filesystem. This allows the BeagleBone Black to bypass the onboard eMMC and boot from the removable uSD (provided no valid boot device is found on SPI0.) This can be used to recover from a corrupted onboard eMMC/U-Boot. If the boot switch (S2) is held down during power-up, the ROM will boot from the SPI0 Interface first, followed by MMC0 (external uSD), USB0 and UART0. For this reason, a cut down version of U-Boot called U-Boot SPL (Second Program Loader) is loaded first, and once it has initialised the CPU, it chain loads a fully featured version of U-Boot (u-boot.img).īy default, the ROM code in the Sitara AM3359 will boot from the MMC1 interface first (the onboard eMMC), followed by MMC0 (external uSD), UART0 and USB0. The internal RAM on the AM335X is 128KB, but due to various limitations, only 109KB is available for the initial bootloader for program memory, heap and stack.Ī fully featured version of U-Boot can be over 400KB, hence it is not possible to load this immediately. On reset, this ROM code searches for the bootloader and then copies it to the internal RAM before executing it. The AM335X contains ROM code that can load a bootloader from external memory such as the on-board eMMC. 1.6 Setting up the environment area on your uSD Card.1.4 Setting Environment Variables for booting from TFTP/NFSRoot.1.3 Saving the Bootloader Images to Flash/Card.1.2 Testing the fully featured second stage U-Boot Bootloader.1.1 Compiling U-Boot for the BeagleBone Black. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |